Upcycled Fragrance Warmer

Anyone who lives in an older home like Chez Ginger knows that they can have a certain "nasal patina" that just comes with the territory. And anyone who has a kitty like Miss Shelby knows that they come with their own set of odors, as well. So Miss Ginger is quite experienced with the many gizmos and gadgets designed to fragrance the home. They can be quite expensive, if not initially, then long term as their liquids, oils, and nonesuch have to be replaced.

Here's an upcycle that gives your home the scent of fresh laundry, using castaway glass bottles and an inexpensive "filler" to be revealed later.

You'll need some empty "longneck" beer bottles, or other bottles of a similar diameter, and some empty wine bottles.  You'll also need a bottle cutter, and a "dremel" tool with a diamond wheel cut-off blade.

Be sure your wine bottles have a nice, deep "punt" on the bottom of them. You'll see why this is important in a minute.

Cut your beer bottles below the neck but above the label.  Miss Ginger leaves the label in place, because she uses it as a cutting guide, and removes it later, but you don't have to.  Cut the wine bottles about half an inch or so from the bottom, so you are left with pieces that look like little glass sombreros. 

Next, use the diamond-wheeled saw to carefully cut around the small label on the back. You are literally going to cut the label off, glass and all.  Start by gently guiding the wheel along one side of the label to create a scratch.  Put a drop of cutting oil (it comes with the blade) onto the scratch (the scratch keeps the oil from rolling off) and continue to cut along the line until you have ground all the way through. Once you have cut all four sides of the label it will drop through. It may take a little practice to learn the best way to cut the label away, and beer bottles are made of very cheap glass, so you may break a few before you get the hang of it. Be sure to wear gloves and goggles for this part!

If all goes well, it will look like this.  On the other side of the bottle, cut a smaller hole, or a series of slits, or some other shape to allow air to flow through.

Often, the glass will break at the top of the 2 vertical cuts, like you see here. As long as there are no other cracks in the glass, this is okay... you really won't see it once everything is set up.

Once everything is cut, use emery cloth or a diamond bit to remove any sharp edges, peel any remaining labels off, and give everything a good wash. (Bonus tip:  WD-40 is a cheap and effective product to remove just about any kind of adhesive residue, and it's cheaper than those "goo" products you buy just for that purpose. But it stinks, so use it outside!)  Flip the "sombrero" over, place it on top, and you're ready to load!

Here's the secret ingredient: Downy Unstoppables Fabric Softener. This exact brand is actually made up of little wax pellets impregnated with fragrance that are supposed to go into your washer.  Miss Ginger has not used it for that purpose, since it really doesn't seem like it would be good for your washer, the drain, or your clothes, but hey, who is she to judge?!

Fill the little sombrero with pellets, drop in a candle, light it, and wait a few minutes.  The candle will warm the pellets until they melt, releasing the fragrance of fresh washed laundry for hours!  The fragrance lasts through many lightings, even if the pool of pellet juice cools and hardens; just put in a new candle and remelt it!

DISCLAIMERS: Use common sense when burning any candle!!
DO NOT leave any burning candle unsupervised!
Place on a non-flammable surface.
Ensure a safe distance from curtains, fabrics, paper, etc.
Keep away from children and pets.
Do not move the unit until the candle is extinguished and the wax has hardened.

The maker of Downy Fabric Softener make no claims for the suitability of their product for this purpose. Use at your own risk.

But trust Miss Ginger:  it smells WONDERFUL!  Make one for every room and it's like a whole house full of "clean sheet night!"